How much to upgrade to better grain orientation? View answer
Asked 2 ´years ago | 36" Pulaski Axe Handle
Asked 5 ´years ago | 1/4" x 4" Forged Eye & Eye Turnbuckle - 500 lbs WLL
Hello there! Will the cold shut holes of this fit through this link? Thank you! https://www.westechrigging.com/cold-shut-zp-012.html#_ga=2.14086900.237013150.1590166988-1295142309.1590166988&_gac=1.48900882.1590167243.EAIaIQobChMI0NW2sOik6QIVkIvICh03cQ1rEAQYAiABEgIYQfD_BwE View answer
Asked 4 ´years ago | 3/8" Zinc-Plated Steel Quick Link - 1800 lbs WLL
Is this galvanized steel? View answer
Asked 3 ´years ago | Chicago 1-1/2" Tap Heavy-Duty Eye Nut - 35600 lbs WLL
Asked 4 ´years ago | Viking Orange Rubber Calk Chainsaw Boots
Do you have women's sizes? View answer
Asked 5 ´years ago | Red Steer Chilly Grip Water-Resistant Thermal Glove
When will these be back in stock? View answer
Asked 4 ´years ago | Fusion Z-Max Hyper Speed Handle Bar Trolley
We have an enclosed trailer that was modified to haul classic cars. The rear ramp, modified with steel and 3/4 plywood, weighing about 800 lbs., is raised and lowered by a 2500 lb. winch. 5/16 cable runs over a 2" pulley suspended at the ceiling, just inside the door. After only about 20 open/close cycles, at a point EXACTLY 10 inches up from the thimble where cable attaches to the ramp, the "core" stand of the cable begins to protrude about a 1/2 inch. I tried steel, stainless, and galvanized; always happens in the same spot, same time frame! Any ideas why? I've cut 16" off the end, replace thimble and clamps, and it happens again! View answer
Asked 3 ´years ago | 5/16" 7x19 Stainless Steel Aircraft Cable - 9000 lbs Breaking Strength
Is there a saw head adapter for this kit? View answer
Asked 2 ´years ago | Notch 12 ft Telescoping Pole Pruner Kit
Does this come with or can splices be added before buying? View answer
Asked 4 ´years ago
What is the lifting load limit? View answer
Asked 4 ´years ago | Crosby S-264 #1 Pad Eye - #1090740
What is the warranty? View answer
Asked 4 ´years ago