Is this made in the USA? View answer
Asked 2 ´years ago | Durabilt 6" Snatch Block w/ Hook - 8 Ton WLL
Is it an issue to run 1/4" or 7/16" cord? View answer
Asked 6 ´years ago
Do you have 12 of these in stock? View answer
Asked 5 ´years ago
How wide is the hoe part of the head? View answer
Asked 4 ´years ago
Do u have anything bigger than this ? View answer
Asked 3 ´years ago | Ergodyne 5743 Plastic-Bottom Hoist Bucket
Where do you grease these blocks? View answer
Asked 2 ´years ago | Young 1569 Half Side Haulback Block - 15 Ton WLL
Do you have them in 1/4" x 1-1/4"? View answer
Asked 6 ´years ago | SpeeCo 1/4" x 1-1/2" Ball Detent Pin
Hello, I have a Hayate saw and found this FOXADP adapter on a site in the UK. http://www.silkyfox.co.uk/accessories.phpAdaptor for Sintung 50 - This adaptor converts the fitting on a Sintung 50 lopper to allow for connection to a Hayate pole saw.Do you have access to these?Thank you, Jim View answer
Asked 5 ´years ago
What is the minimum load requirement for this clamp? I would be using this clamp to habitually lift 3/8" thick steel plate that weighs between 375 and 400 lbs in a 36" x 98" sheet. Since it is advisable for safety and longevity of the clamp to lift as close to the max capacity as possible, if this clamp will not work, do you have another model # that will? View answer
Asked 3 ´years ago | AMH 1 Ton Vertical Plate Lifting Clamp - #PCUA010
What is the height? View answer
Asked 6 ´years ago
Asked 4 ´years ago
Is the belt removable? View answer
Asked 4 ´years ago
What is the Working Load Limit formula for the UHMWPE rope? View answer
Asked 3 ´years ago
Will this cable work well on a winch? The 3/8" cable I have now on my Harbor Freight 12,000# winch is stiff and hard to work with! What would be the cost to add a thimble and a safety hook on one end? View answer
Asked 3 ´years ago | 3/8" 7x19 Stainless Steel Aircraft Cable - 12000 lbs Breaking Strength
Does it cut in both directions? View answer
Asked 6 ´years ago | Forester Portable Hand Chainsaw
Can you get this pulley with bearings? View answer
Asked 6 ´years ago | ISC RP066 Large Pulley
Do you do a 240V AC version of this? View answer
Asked 6 ´years ago